Replacement top box to rear luggage rack lock for Hepco and Becker Junior top boxes / top cases. This is the lock at the base of the top box which attaches it to the luggage rack

Supplied with key, rivets, lock plate and fitting instructions

 1 in stock

Brilliant chrome, aluminium and metal polish.

Make your Guzzi gleam.

 1 in stock

Polished aluminium instrument console kit for 80mm instruments (as used on Le Mans 1, 2, T3, V50 etc...). This high quality kit is specially made for Gutsibits and consists of the following parts:

• Polished aluminium clock surround front with 80mm holes for instruments, slotted ignition switch hole and 8mm instrument light holes
• 6 LEDs with chrome bezels (small spade connectors to rear) for indicators, oil, charge system, neutral and high beam warning light
• Polished aluminium instrument surrounds (odometer surround includes hole for reset knob)
• Polished aluminium instrument backs (attach with existing nuts)

Manufactured from 6mm aluminium, this this instrument binnacle will not fatigue with use and is an excellent way to present the standard 80mm Veglia instruments. Bolts to handlebar yoke clamps. NB instruments and ignition switch shown in photo for illustration purposes only.
This is a high quality UK manufactured part made exclusively for Gutsibits, do not confuse with lesser alternatives. These kits are often prepared to order so please allow for a couple of days delay before your order is sent.

NB This kit works with the ignition switch ELA17735, later type switches will not fit into the predrilled ignition switch hole. On models with cable operated remote odometer resets the reset knob will need to be relocated. Check the depth of your instruments before ordering, this kit is intended for 48mm deep instruments with 60mm stud centres

Instruments with 60 degree or similar angle drives to the rear will require you to enlarge cable cutouts in the plates that make up the rear of the kit

 1 in stock

6 pin male block connector, used for main loom connections. See ELA30001 for female 6 block connector.

 1 in stock

200073020

Five piece decal set, gold lettering. Three larger decals, two smaller decals

 1 in stock

The innovative stahlbus bleeder valve allows you to change the brake fluid yourself without assistance.

Linked Guzzi brake systems are notoriously tricky to bleed, this special bleed nipple can save you hours of tedious squeezing and pumping! This banjo bolt can be used in place of a standard fine thread M10 banjo bolt. Supplied with crush washers. We recommend fitting one of these brake valves per caliper
The innovative stahlbus vent valve allows you to change the brake fluid easily and without help. Clean, totally safe and fast !
This auto bleed valve combines all these advantages:

• Completely sealed by O-ring.
• Hydraulic system remains sealed even during the venting process.
• Reliable non-return function, thus one-man operation.
• System has been bled in minutes.
• Wear of the threads in the caliper is prevented (up and screwing down during the bleeding process).
• For all hydraulic systems such as brakes and clutches stahlbus brake bleed valve just replaces the existing vent screw.
• Tested under extreme conditions by TÜV Rheinland.
  See BRA41652 for bleed valve cover

   1 in stock

  [ CLOSE WINDOW ]
  [ CLOSE WINDOW ]

Chrome bar end mirror with a large round head and adjustable arm. Fits all models with open ended (i.e. not threaded) 7/8 inch steel handlebars.

Can be fitted on either left or right hand side of handlebars. Shown here fitted to a handlebar which is not included

 1 in stock

High performance Quadflex maintenance free Motobatt 12 volt 14Ah battery. Quadflex technology means you have two positive and two negative threaded terminals allowing maximum flexibility when installing. Motobatt absorbed gel matting batteries feature the latest absorbent glass mat technology. This offers increased lifespan, higher vibration resistance and electrical performance. This battery is also leak, vibration and spill proof if installed correctly.

NB this battery is physically smaller than the OE battery fitted to the Quotas

200 CCA.
4 x M6 terminals
Supplied charged and ready to fit with terminal brackets and button head screws.
NB This battery must not be trickle charged or charged using a traditional manual charger, AGM batteries require a smart charger - we recommend ACA96000
For more information on charging AGM batteries see these FAQ's.

If parking your bike up for several weeks we recommend disconnecting one battery terminal to prevent battery drain, this should ensure your bike will start once you are ready to use it again. Replaces YTX12BS, YTX14BS, YTX14LBS, KMX14BS, YTX15LBS and Odyssey PC545. Replaces Guzzi ref. 638733, this battery is for small twins with a single throttle body

One year warranty on all our Motobatt batteries

Also available at the same price in black by special order - call 01484 841395 to order. If you need more performance than a standard AGM battery offers see hybrid battery ELA59015 which ouputs 330 CCA for starting the highest performance twins

Please note this part CANNOT be posted outside of the UK mainland area

 1 in stock

 638733 MG638733

Universal hydraulic brakelight switch. This hydraulic switch replaces discontinued brake light switches by bolting in place of a double banjo bolt on the handlebar or rear brake master cylinder

Especially suitable for replacing the standard switch on models where the front brakes have been 'de-linked'

 1 in stock

Pair of black alloy bar end extensions to enable fitment of Clubman mirrors to V7 and V9 models with threaded handlebar ends without needing to move switchgear inboard. Mirrors can be fitted without these but the handlebars need drilling for the switchgear locating pegs

 1 in stock